IMPORTANT POSITIONS IN THE FLOORING

A) Check the water installation and remove any leaks.

B) The temperature of the environment at the time of placing the parquet must not be less than 15 C.

C) All construction work must be over except of the laying the last layer of paint.

D) To achieve balance the parquet with moisture of the environment, the parquet should be taken out of the packing previously.

E) The windows and the windowpanes should be installed to control moisture in the room.

F) Choose a polyurethane adhesive with two components.

G) The solid parquet is ranked parallel to the length of the room.

H) After finishing placing the parquet you have to wait at least three weeks to scrape and varnish.

I) At the ends of the walls leave empty space (1,5 - 2cm).

J) It is desirable to work with a team specialized in placing parquet.

SCRAPING AND VARNISHING

A) The scraping is done with a coarse sandpaper to a fine sandpaper. The second scraping is done with a finer sandpaper and the third with the finest sandpaper.

B) After jointing use again the fine sandpaper.

C) After the last scraping, the dust on the surface should be cleaned well.

D) Varnish it to three layers using a roller, between the varnished coating should be ground.

When scraping and varnishing you should observe this order and sequence;

CARES FOR THE PARQUET

A) Put rubber fuses under the furniture to prevent the parquet from scratching.

B) Use a vacuum cleaner and slightly damp cloth to clean.

C) Pay attention not to soak the parquet, if you spill water wipe it immediately.

D) Keep the temperature from 18 C to 23 C and the humidity of the air in the room from 40% to 60%.

Having kept these rules you may achieve the desired result.